Switching The Alarm Function On/Off; Activate Snooze Function Or Terminate Alarm; Temperature Alarm - Renkforce 1267774 Notice D'emploi

Switching the Alarm Function On/Off

• Push the button „MODE" (A) sevaral times until either the alarm time 1 (display „A1"
to the right of the alarm time) or the alarm time 2 (display „A2" to the right of the alarm
time) is displayed.
• Briefly press the button „-" to activate or deactivate the alarm function.
If alarm time 1 is on, the symbol „
If alarm time 2 is on, the symbol „

Activate Snooze Function or Terminate Alarm

• The alarm signal is activated at the set alarm time and the bell symbol „
time 1) or „ " (for alarm time 2) flashes.
• Pushing the button „SNOOZE/LIGHT" (G) interrupts the alarm signal for the duration
of 5 minutes. During this time, the bell symbol continues to flash.
Then the alarm signal is started again.
This procedure can be repeated several times.
• To terminate the alarm signal (or snooze mode), push any button on the rear of the
weather station.
The alarm signal is automatically terminated after 2 minutes if no button is
pushed.
e) Temperature Alarm
An upper and lower temperature limit can be set for each of the outdoor sensor channels
(1, 2, 3) and an alarm signal can be emitted when the value leaves the range.
• First select the desired outdoor sensor channel with the button „CHANNEL" (E).
• If you keep the button „-" pushed for 3 seconds, „ON" or „OF" will flash to the left of
the display in the outdoor temperature display area. Release the button again.
• Use the button „+" or „-" to switch the temperature alarm on („ON") or off („OF").
• Briefly push the button „MODE" (A). The temperature value for the upper temperature
limit flashes, and the symbol „ " appears above the time.
• Set the upper temperature limit with the buttons „+" and „-". Keep the respective
button pressed for quick adjustment.
" appears on the right of the display.
" appears on the right of the display.
" (for alarm
41