Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
B
SLICING/GRATING
The general assembly steps are shown in figure B.
1.
Fit the spindle to the top of the motor unit.
2.
Lower the workbowl on to the motor unit, then turn it clockwise to lock it
in place.
3.
Lower the disc over the top of the spindle with the slicing or grating side
facing upwards depending to whether you want to slice or grate the
ingredients.
4.
Hold the lid with the tube slightly behind the workbowl handle, set it on
the workbowl, then turn it clockwise to lock the tab into the top of the
handle.
5.
Remove the pusher, and drop the ingredients down the tube.
6.
Replace the pusher, and use it to push the ingredients gently down the
tube.
•
Don't use fingers or cutlery to push food down the tube – only the pusher.
•
Don't let the work workbowl get more than about half full – stop and
empty it.
•
To remove the lid, turn it counter-clockwise to unlock it, then lift it off.
CARE AND MAINTENANCE
Switch the appliance off O and unplug it.
1.
2.
Wipe the outside of the motor unit with a clean damp cloth.
3.
Wash the removable parts by hand, in warm water with dish soap, or in a
dishwasher.
If you use a dishwasher, the harsh environment inside the dishwasher will
affect the surface finishes. The damage should be cosmetic only, and should
not affect the operation of the appliance.
7
Publicité
Table des Matières
