Refrigerant Piping Work - Daikin FAQ18PVJU Manuel D'installation

(8) Connect the piping. (See "5.REFRIGERANT PIPING WORK" and Fig. 10)
Drain hose
Transmission wiring
and remote controller
wiring
Seal with putty corking material.
Fig. 10
• Seal the piping through-hole with putty corking material.
(9) Push on both bottom edges of the indoor unit using both hands and hook the tab on the back of
the indoor unit onto the installation panel (1). (Refer to Fig. 9)
• At this time remove the buffering material placed in step (6).
• Make sure power supply wiring, transmission wiring, ground wiring and remote controller wiring are
not caught inside the indoor unit.
When screwing in the indoor unit
• Remove the front grill.
• Secure the indoor unit to the installation panel (1) with the securing
screws (6). (Refer to Fig. 11)
5.

REFRIGERANT PIPING WORK

〈For refrigerant piping of outdoor units, see the installation manual attached to the outdoor unit.〉
〈Execute heat insulation work completely on both sides of the gas piping and the liquid piping.
Otherwise, a water leakage can result sometimes.〉
(When using a heat pump, the temperature of the gas piping can reach up to approximately 250°F, so use
insulation which is suffi ciently resistant.)
〈Also, in cases where the temperature and humidity of the refrigerant piping sections might exceed
86ºF or RH80 %, reinforce the refrigerant insulation. (13/16" or thicker) Condensation may form on
the surface of the insulating material.〉
〈Before refrigerant piping work, check which type of refrigerant is used. Proper operation is not
possible if the types of refrigerant are not the same.〉
DANGER
• Refrigerant gas may produce toxic gas if it comes in contact with fi re such as from a fan, heater, stove or
cooking device. Exposure to this gas could result in severe injury or death.
English
Secure with
vinyl tape.
Refrigerant piping
Conduit
Wrap the insulating tape overlapping at least half the width with each wrap.
Wrap the insulating tape all the way to the L-shaped bend.
(Refer to Fig. 7)
Refrigerant piping
Transmission wiring and
A
remote controller wiring
A arrow view
Fig. 11
Installation panel
(accessory) (1)
Refrigerant piping
Insulating tape
(accessory) (4)
M4 × 12L
(accessory) (6)
10