Sliding Dishwasher Into Cabinet - LG LDT780 Serie Manuel Du Propriétaire

16 INSTALLATION
Attaching Mounting Hardware
For countertops made of wood or other material
that will not be damaged by drilling, use the metal
installation brackets.
1
Insert the installation brackets into the slots in
the upper frame.
2
Installation bracket
2
Bend the brackets to secure them to the
dishwasher tub.
NOTE
• Installation brackets and screws can be found in the
silverware basket.
For countertops made of granite, marble, or other
materials that could be damaged by drilling, use the
wood screws to attach the dishwasher to the cabinet.
See installation instructions in Securing Dishwasher
to Countertop.
CAUTION
• Ensure the dishwasher is level and all legs are
in firm contact with the floor before attaching the
dishwasher to the countertop or cabinet. If the
product is not leveled properly, the door may not
close or water may leak.
1
Cap
Screw
Sliding Dishwasher into
Cabinet
1
Slide the dishwasher carefully into the cabinet
opening.
2
Make sure the drain hose inside the cabinet is
not kinked or pinched.
3
Make sure the water supply line and electrical
supply are routed through the channels under
the dishwasher.
4
To avoid a kinked or pinched drain hose, be
sure to pull on the drain hose while sliding the
dishwasher into place. Do not allow any slack
behind the dishwasher.
5
After leveling the dishwasher, do not leave the
water supply line or power supply line under the
base. This is a potential cause of water leaks.
Place the water line and power supply line in the
channel.
CAUTION
• The opening in the side of the cabinet may have
sharp edges. To avoid damaging the drain hose,
smooth out or pad the edges of the opening. Pull
the drain hose through the opening slowly and
carefully.