Pre-Operation Checklist - Flexzilla CF10050F Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Flexzilla Electric Operated, Oil-Free Portable Air Compressors

7. PRE-OPERATION CHECKLIST

Initial Set-up:
Package Contents:
1.) Air compressor
2.) Owner's Manual
3.) Air Filter Kit (2)
- Includes pre-assembled unit consisting of male housing, female
housing, filter element, and intake tube
4.) Anti-Vibration Foot Kit (4)
- Includes elastomer pad, screw, and nut
5.) Wheel Kit (2)
- Includes wheel, bolt, flat washer, lock washer, and nut
5.) Hot Surface Protection Kit (2)
- Includes plastic head cover, head cover clamp, 2 screws
Assembly:
1.) Install Foot Kit (2 Locations)
- Lay down compressor handle side down to prevent unit from rolling
- Insert bolt through elastomer foot and through hole located in frame
- Thread nut onto bolt, lightly tighten
- Repeat at remaining location
- Leave compressor in this position for step 2
2.) Install Wheel Kit (2 Locations) (CB20100F/CB20200F models only)
- Lift compressor slightly to raise wheel off ground
- Insert bolt through wheel and through hole in bracket
- Install flat washer over bolt
- Install lock washer over bolt
- Thread nut onto bolt and tighten with wrench
- Repeat at remaining position
- Tip compressor upright by using the handle
3.) Install Air Filter
CF10050F (1 Location)
- When facing the front of compressor, locate the thread port in
motor head along left side
- Thread filter into port, and tighten by hand securely
CB20100F/CB20200F (2 Locations)
- When facing the back of compressor, locate the thread ports near
the top of the motor head behind the handle
- Thread filter into port, and tighten by hand securely
4.) Install Hot Surface Protection Kit (2 Locations)
- When facing the rear of the compressor, place plastic head cover
over the cylinder head
- Note: The screw holes are located near the center of the
compressor pump
- Place head cover clamp below the plastic head cover
- Insert the 2 screws and tighten with PH2 screw driver securely
(CB20100F/CB20200F)
10
FOOT KIT DIAGRAM
Bolt
Elastomer Foot
Screw
WHEEL KIT DIAGRAM
Bolt
Wheel
Flat Washer
Lock Washer
Nut
AIR FILTER LOCATION
(CF10050F)
AIR FILTER LOCATION
(CB20100F/CB20200F)

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Cb20100fCb20200f

Table des Matières