Additional Requirements; Installation Process; Step 1 -Attach Support Brackets To Base - Uberhaus 70005028 HSS-A-GH Guide De L'utilisateur

WARNING
California Proposition 65
Combustion by products produced when using
this product contain chemicals known to the state
of California to cause many serious diseases
such as cancer.
Hardware
Picture Qty
3
6
6
6
3
6
6
4
9
9
9
9
3
3
1
4
Used in
Description Step(s)
Ground Bracket 1
Small Bolt
1
1
Small Flat Washer
Nut
1
Medium Bolt 1
Large Bolt
2
Small Flange Nut 2
Small Bolt 5
Small Screw 6
Large Flat Washer 4 / 7
Small Flat Washer
6
Cap Nut 6
Wing Nut 7
Reflector Stud 4
Wrench
1 / 2 / 5 / 6

Additional Requirements

The following items are not included, but are necessary for
. .
the proper assembly of your heater. Do NOT attempt to
assemble without proper tools.
.
Philips screwdriver w/ medium blade.
Adjustable opening wrench.
Leak Detection Solution (Instructions on how to make
solution are included on page 8)
Note: You must follow all steps to properly assemble
heater.

Installation process

Step 1 – Attach Support Brackets to Base
To protect heater from strong wind, anchor
the base securely to the ground
with screws.
Reverse the base, fix the
ground bracket to the base with
bolts and washers like picture
shows.
Firm the ground bracket with
nuts.
Fix another two ground bracket with bolts and nuts,
and reverse the base.
.
Attach three Support Brackets loosely to Base with
three medium bolts downward through Support
Brackets into the Base.
3 Medium Bolts