Product Information - VONROC CD802AA Traduction De La Notice Originale

b) Never service damaged battery packs. Service
of battery packs should only be performed by the
manufacturer or authorized service providers.
SAFETY WARNINGS FOR CHARGER
Intended use
Charge only CD801AA and CD803AA type rechargea-
ble Battery packs with the charger. Other types of bat-
teries may burst causing personal injury and damage.
a) The appliance is not to be used by persons
(including children) with reduced physical, sen­
sory or mental capabilities, or lack of experien­
ce and knowledge, unless they have been given
supervision or instruction.
b) Children being supervised not to play with the
appliance.
c) Do not recharging non­rechargeable batteries!
d) During charging, batteries must be placed in
the well ventilated area!
ELECTRICAL SAFETY
Always check that the voltage of the power
supply corresponds to the voltage on the
rating plate.
• Do not use the machine if the mains cable or
the mains plug is damaged.
• Only use extension cables that are suitable
for the power rating of the machine with a
minimum thickness of 1.5 mm
tension cable reel, always fully unroll the cable.

2. PRODUCT INFORMATION

Intended use
Only use the following batteries of VONROC POWER
20V battery platform. Using any other batteries could
cause serious injury or damage the charger.
CD801AA 20V, 2Ah Lithium-Ion
CD803AA 20V, 4Ah Lithium-Ion
The batteries of the VONROC POWER 20V battery
platform are interchangeable with all the VONROC
POWER 20V battery platform tools.
TECHNICAL SPECIFICATIONS
Model No
Charger input
Charger output
Charging time 2Ah battery
WWW.VONROC.COM
Charging time 4Ah battery
Recommended batteries
Weight
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2.
1. Battery unlock button
2. Battery LED indicators button
3. Battery LED indicators
4. Battery (not included)
5. Charger
6. Charger LED indicators
3. OPERATION
Inserting the battery into the machine (Fig. B)
1. Insert the battery (4) into the base of the machine
. If you use a ex-
2
2. Push the battery further forward until it clicks
Removing the battery from the machine (Fig. B)
1. Push the battery unlock button (1).
2. Pull the battery out of the machine like shown in
Charging the battery with the charger (Fig. A)
1. Take the battery (4) from the machine.
2. Turn the battery (4) to upside down position and
3. Push the battery until it is fully pushed into the
4. Plug the charger plug into an electrical outlet
CD802AA
220-240V,50Hz 0.4A
21V 2.5A
60 minutes
Before any work on the power tool, remove
the battery.
The battery must be charged before first use.
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
as shown in Fig. B.
into place.
Fig. B.
slide it onto the charger (5) as shown in Fig. A.
slot.
and wait for a while. The LED indicators on the
charger (6) will lighten up and show the charger
status.
EN
120 minutes
CD801AA, CD803AA
0.36 kg
5