Publicité
Les langues disponibles
Les langues disponibles
1. Installation
Installing the Airmax
LED Light Set (Fig. 5)
®
1) To attach the light, clip the light into the inner mounting positions on the float
and use the vertical tension screw to secure the light into place. Continue
until all lights are attached.
2) After attaching the Airmax
®
LED Light Set to the float, connect the quick
disconnect end to the power cord.
3) Attach the light set power cord strain relief on to one of the loops underneath
the float mount ring.
4) Adjust the lights to point in the desired direction.
5) Connect the light set's power cord into the control panel or other GFCI outlet.
2. RGBW Remote Control Instructions
The Airmax
®
Color-Changing RGBW LED Light Set is run by a wireless remote
with a range of up to 200ft. The wireless remote allows you to change the color,
dim/brighten the lights, control flash speed and run up to 9 preset programs.
Your wireless remote has already been paired for your light set on Zone 1.
Requires: 2 AAA Batteries(Included).
Basic Control Functions
• Press and Hold Master ON or ZONE ON for several seconds to turn all lights to
white mode (Fig. 6)
• Touch the color ring to adjustment lights to any color.
• Change the brightness by using the brightness slide ring.
• Adjust flash speed for any preset program using the speed buttons.
Preset Programs/Modes
Press the "M" Mode button to scroll through the pre-programmed light
settings:
Program 1 - RGBW Fade In/Fade Out
Fades in and fades out the color red, green, blue and white one after another.
Program 2 - Color Flash
Red, green, blue, white, yellow and purple flashes.
Program 3 - Disco
Multiple colors strobe and flash.
Program 4 - Red Color Ramp Up and Flash
Red color brightens from 0%‐100% and shuts down, then flashes three times.
Program 5 - Green Color Ramp Up and Flash
Green color brightens from 0%‐100% and shuts down, then flashes three times.
Program 6 - Blue Color Ramp Up and Flash
Blue color brightens from 0%‐100% and shuts down, then flashes three times.
Program 7 - Color Change and Flash
Several colors fade into each other and then flash randomly.
Program 8 - Fade In/Fade Out
Several colors fade into each other.
Program 9 - Strobe White
White color flashes.
Fig. 5
Fig. 6
Color Ring
Brightness
Indicator
Master On
Speed -
Zone On
Zones
Zone Off
(Programs)
NOTE:
Your wireless remote has aleady been paired for your light set on Zone 1.
In the event that your light set becomes unpaired or to link additional
lights to the remote, follow the steps below.
Linking new lights to the remote control:
1. Choose which zone you want to assign the lights (1 to 4)
2. Switch off the main power supply of the lights in the selected zone
with the main switch or pull the plug from the socket.
3. Now switch on the lights again and within 3 seconds shortly press
one of the 'Zone ON' buttons, one time, on the remote control.
4. When the link operation is successful, the lights will slowly blink on
and off 3 times.
ENGLISH
Indicator
Master Off
Speed +
Modes
3
Publicité
