Before Use - Dynalab Merit W4000 Instructions De Montage Et De Fonctionnement

Merit Water Still W4000 & W4000/EURO
Thermostat reset buttons
Heater
Gaskets and
Figure 1 General assembly

BEFORE USE

If the equipment is not used in the manner described
in this manual the protection provided by the
equipment may be impaired.
N.B. The Merit Water Still is classified as
"Permanently Connected Equipment" and should be
connected to the electricity supply by a qualified
electrician in the manner described in the electrical
installation section of this manual.
The Merit Water Still is designed to operate under the
following conditions:
For indoor use only
Ambient temperature range +5°C to +40°C
Altitude up to 2000m
Relative humidity not exceeding 80%
Mains supply voltage fluctuations not greater than
±10% of nominal
Overvoltage category II IEC664
Pollution degree 2 IEC664
[ 2 ]
Condenser
Boiler
Vent
flange
Cooling water
inlet
Distillate
Straps
outlet
The Merit Water Still complies with the
following European Directives:
89/336/EEC - E.M.C. DIRECTIVE
Amended by 92/31/EEC and 93/68/EEC
73/23/EEC - L.V.D. Amended by 93/68/EEC
Limitations of use
This product meets the applicable E.C. harmonised
standards for radio frequency interference and may be
expected not to interfere with, or be affected by other
equipment with similar qualifications. We cannot be sure
that other equipment used in its vicinity will meet these
standards and we cannot guarantee that interfer ence will
not occur in practice. Where there is a possibility that injury,
damage or loss might occur if equipment malfunctions due
to radio frequency interference, or for general advice before
use, please contact the Technical Service Department of
Bibby Sterilin Ltd.
Constant level
control
To drain
Stopcock