Publicité
Les langues disponibles
Les langues disponibles
US
competence of the user, how well the product is stored and maintained, etc.
ATTENTION: in extreme cases, the lifetime of the product can be reduced to
even one single use through exposure, for example to any of the following:
chemicals, extreme temperatures, sharp edges, major fall or load, etc.
INSPECTION: Inspect equipment periodically for damage and/or deterioration.
lf you find any minor cuts, abrasions, or other visible damage, make
sure the helmet is inspected before further use. In addition to the inspection
before and during use, a periodic in-depth inspection should be carried out by
a competent inspector at least once every 12months. The frequency of the in-
depth inspection must be governed by the type and the intensity of use. To keep
better track of your equipment, it is preferable to assign each piece of equipment
to a unique user so that he/she will know its history. The results of inspections
should be documented in an "inspection record". This document must allow
recording of the following details: type of equipment, model, name and contact
information of the manufacturer or distributor, means of identification (serial or
individual number), year of manufacture, date of purchase, date of first use, name
of user, all other pertinent information for example maintenance and frequency
of use, the history of periodic inspections (date, comments and noted problems,
name and signature of the competent person who performed the inspection).
SHELF LIFE: The shelf life of the helmet depends on the occurrence of different
degenerative factors, including changes in temperature, exposure to direct
sunlight, and frequency of use. The helmet must be checked regularly, and before
each use, to detect the presence of any damage such as cracks, detachments,
deformities, peeling that represent factual elements of the state of deterioration
of the helmet. Helmets that have suffered a several impact shall be replaced
even if they do not show obvious signs of damage. The maximum lifespan of this
product is 10 years from the date of manufacture. After this period, the helmet
must be disposed of.
PRODUCT OBSOLESCENCE: There are many reasons why a product may
be judged obsolete and thus retired before the end of its actual lifetime.
Examples include changes in applicable standards, regulations, or legislation;
development of new techniques, incompatibility with other equipment, etc.
WHEN TO RETIRE YOUR EQUIPMENT: Immediately retire any equipment if:
- it fails to pass inspection (inspection before and during use and the periodic
in-depth inspection);
- it has been subjected to a major fall or load;
- you do not know its full usage history;
- it is at least 10 years old
- you have any doubt as to its integrity.
5
Publicité
