Bluetooth Operation - Daewoo International DCR-300 Manuel D'instructions

NOTES:
• The LED display will change to show the clock time after a few seconds.
• Tap the TUNER- BUTTON (#4) OR MIN/TUNER+ BUTTON (#5) to check the tuned
frequency.
Setting the Radio Station Presets
The unit allows you to store up to 30 FM stations for easy recall at any time.
1. Press the MODE BUTTON (#2) repeatedly to turn on the unit and select FM Mode.
2. Tune to the radio station you want to store in memory.
3. Press and hold the CLOCK / MEM / PRESET BUTTON (#3).The preset channel number
"P01" will be ashing on the display.
4. To change the preset channel number location, press the HOUR / TUNER- BUTTON
(#4) and MIN/TUNER+ BUTTON (#5) to step through the preset locations.
5. To con rm the preset location, press CLOCK / MEM / PRESET BUTTON (#3).
6. To store another station presets, repeat steps 2-5 above.
RECALL PRESET STATION
In FM mode, press the CLOCK /MEM / PRESET BUTTON (#3) repeatedly to select the
preset channel.
TIPS FOR BEST RADIO RECEPTION
FM - If FM reception is weak, fully extend the wire antenna and vary the position and
location of the antenna until you nd the strongest signal.

BLUETOOTH OPERATION

The unit has a Bluetooth function that can receive a signal within 8 metres.
Pairing the unit with a Bluetooth device to listen to music:
1. Press the STANDBY button on the remote control or BUTTON (#1) to turn on the
power on .
2. Press MODE button to turn on the BLUETOOTH mode.
3. If the unit is not paired with any Bluetooth device, the LED display will ash "BT"
Bluetooth will show on the LED (#25) Display
4. Activate your Bluetooth device and select the search mode.
5. "DCR-300" will appear on your Bluetooth device list.
6. Select "DCR-300" and enter "0000" for the password if necessary.
7. To disconnect the Bluetooth function, press the MODE button to switch to another
mode or disconnect the function from your Bluetooth device.
EN
18