Berger & Schroter BG310 Serie Mode D'emploi page 42

Main Options
PIR Trigger /
Sensitivity
PIR-Interval
Work Day
Work Hour
Camera Position Used for multiple cameras in an area.You can set an A-Z
Descriptions
This setting is for the sensitivity of the PIR sensor. There are
four sensitivity parameters: High, Normal, Low, and Off. It is
recommended to use HIGH sensitivity in areas with little
environmental interference and warmer, humid climates.
Use LOW sensitivity for areas that have a lot of interference.
The sensitivity of the PIR is affected by temperature. Higher
temperatures lead to a lower sensitivity.
If PIRTrigger/Sensitivity andTime Lapse options are
BOTH OFF, the camera will not capture any photos or
videos.
Default: Normal
This setting indicates how long the PIR sensor will be
disabled after each camera triggering. During this time the
PIR sensor will not react to any detected motion. The PIR
Interval can be set between zero seconds to a maximum of
1 hour.
Choose the days of the week you want the camera to work
This setting is only available in Hunting Mode.
Default: All
This parameter defines a certain time in a day when the
camera can be triggered, while the device will shut off
during non-working hours. The effective value ranges from
00:00 to 23:59. When this parameter is set to Off, the
camera works at all times. When the timer switch is ON, the
camera works only during the time according to the preset
settings.
Default: Off
indicator for each of your cameras to distinguish between
which photos are from a specific camera.
Default: Off
42