General Description (Fig. 1); Before First Use; Preparing For Use - Philips HR2800 Mode D'emploi

- If food sticks to the wall of the blender jar, switch off the appliance and unplug it. Then use a
spatula to remove the food from the wall.
- Never fill the blender jar with ingredients hotter than 60°C.
- To prevent spillage, do not put more than 1.5 litres of liquid in the blender jar, especially when
you process at high speed (speed 2). Do not put more than 1 litre in the blender jar when
you process hot liquids or ingredients that tend to foam strongly.
- Always make sure the blender lid is properly assembled on the blender jar and the measuring
cup or the spatula is inserted in the lid before you switch on the appliance.
- Do not use any other spatula than the one provided with this appliance.
Electromagnetric fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.

General description (Fig. 1)

a Lid of blender jar
B Blender jar
c Sealing ring for coupling unit
D Coupling unit
E Sealing ring for dispenser
F Dispenser
g Sealing ring for blade unit
H Blade unit
i
Dispenser cover
J Dispensing lever
k Drip tray
l Rubber foot (4x)
m Cord storage facility
n Control knob
o Spatula
p Measuring cup

Before first use

1 Thoroughly clean the parts that come into contact with food before you use the appliance
for the first time (see chapter 'Cleaning').

Preparing for use

1 Fasten the coupling unit to the blender jar (Fig. 2).
Make sure the sealing ring is positioned correctly between the blender jar and the coupling unit.
2 Slide the small sealing ring around the threaded connector of the coupling unit of the blender
jar (Fig. 3).
3 Place the dispenser on the threaded connector of the coupling unit of the blender jar (1).
Screw the dispenser clockwise onto the coupling unit of the blender jar (2) (Fig. 4).
4 Put the thin sealing ring on the blade unit. (Fig. 5)
Make sure that the sealing ring is placed correctly.
5 Insert the blade unit into the bottom of the coupling unit (1). Screw the blade unit anti-
clockwise until it is properly fixed (2) (Fig. 6).
EnglisH
7