Ferplast bluwaterfall corner Manuel D'utilisation page 4

BLUWATERFALL CORNER
EN
CONGRATULATIONS FOR HAVING CHOSEN A BLUWATER-
IT
FALL FILTER BY FERPLAST
BLUWATERFALL is a powerful and easy to maintain filter. It can
be used in different aquarium conditions in order to to ensure
FR
the total health of your fish and plants.
INSTALLING BLUWATERFALL: A FEW RULES, TOTAL SAFETY
D
Before carrying out any installation, please read the following
instructions carefully to ensure your safety and prevent damage
to the product.
NL
• Ensure that the voltage shown on the appliance corresponds to
that of your home electrical power supply.
ES
• The power supply cable cannot be repaired or replaced: if dam-
aged, the whole appliance must be replaced.
• In case of abnormal odour or excessive noise, disconnect the
PT
unit from the power supply and verify the cause. Contact the
shopkeeper.
• Connect the plugs to your electric power supply leaving a loop
SK
in the cable below the electrical socket to prevent drops of wa-
ter running down the cable and into the power supply. (fig. 1)
• Disconnect the appliance from the power supply before carry-
CS
ing out any maintenance work.
• Do not connect the aquarium to the power supply before cor-
HU rectly completing all the installation procedures, including fill-
ing with water.
• Always keep water level over the "minimum water level" line
SV
marked on the filter. (fig. 2)
• Before switching on make sure your home is protected by an au-
tomatic safety breaker switch (or individual breaker plug) with
DA
an operating current of no more than 30 mA.
• Make sure that the filter intake grilles are always cleaned and
never completely obstructed.
RU
• The temperature of the liquid must not exceed 35° C.
• This appliance is intended only for indoor use
PL
Attach the filter in the desired position in the aquarium using
the suckers and the hook provided. The water jet should be
about 1-2 cm below the surface of the water. In this way you
will create an optimum water movement ensuring the ideal gas
change.
ADJUSTING THE FLOW OF WATER
It may be necessary to adjust the BLUWATERFLOW CORNER flow
of water according to the number of fish and size of your aquari-
um. To increase it: turn the control clockwise. To decrease it: turn
the control anti-clockwise. (fig. 6)
CARE AND MAINTENANCE
IMPORTANT: Always disconnect the appliance from the power
supply before removing the filter from the water or carrying
out any maintenance work. Over time, the filtration material in
the filter becomes blocked, reducing the flow of water. Regular
cleaning and/or replacement of the filter cartridge is necessary
to ensure that the filter operates at peak performance.
CLEANING THE FILTER CARTRIDGE
Remove the filter from the aquarium. Open the filter as shown in
the illustration. Remove the filter cartridge. The special sponges
of the filter cartridge must be rinsed at least every two weeks.
(fig. 5)
REPLACING THE FILTER CARTRIDGE
To ensure its effectiveness, the cartridge should be replaced reg-
ularly or, in any case, at least every 2-3 months. The replacement
filtering elements are available at leading retailers.
CLEANING THE ROTOR
The rotor does not need frequent cleaning.
Thanks to its innovative concept, it only needs to be cleaned
every 4-6 months. Use a soft brush and warm water for cleaning.
DO NOT use detergents or abrasives. (fig. 5)