lamber P550-ek Instructions D'emploi page 24

(Attention! During the cycle, at the hood opening
also the steam suction fan starts running for a
maximum time of 20 seconds).
It is possible to interrupt the washing cycle at any
time simply pushing again button "B".
The lighting of the control lamp "D" means that
the water reached the needed temperature of 85°
to 90°C.
The rinsing will start working of by the reached
temperature need. That means the period of the
washing cycle you chosed will be extended up to
having reached the
(thermocontrol).
G
- Take away the basket .
In order to make washing keep on, load
another basket and press pushbutton "C". The
cycle will automatically start again.
Endless cycle (maximum 15 minutes) : the
-
door being closed and the cycle put on (any
cycle), keep the button "B" pressed for 3
seconds: lamps 1 and 2 will flash at the same
time (thermocontrol excluded); the cycle can be
interrupted at any time pressing again button "C"
that will let final sequences start.
Self-washing cycle: with machine on, carry out
the following operations:
- Remove the overflow from the tank and
wait for the tank's emptying (for machines
with drain pump, look at the instructions in
the specific paragraph),
- Close the door of the dishwasher,
- Keep pressed the cycle button ''C'' during
3 seconds: lamp ''2'' flashes during all the
length of the 5 or 10 minutes cycle,
according to the rinse's duration fixed by
default.
DURING WASHING
1) When the machine is running never
change wash time selector position.
2) Only use specific anti-frothing detergents
3) Deactivate the equipment in case of fault
or malfunction. For repairs, only address to a
technical assistance center authorised by the
manufacturer and impose the use of original
spare parts.
If these conditions are not met, the equipment
safety could be jeopardised.
exact temperature
ACHIEVEMENTS
Any deficiency in the washing process is
apparent when dirty residuals are visible. Any
halos might be caused by an insufficient rinsing:
in this case, check that the rinsing jets are clean
and there is a sufficient pressure in the water
distribution network.
In the case that residuals are present, check
that:
• the washing jets are clean
• there is detergent
• the pump suction filter is clean
• the positions of the objects in the rack are
correct.
DRAIN PUMP INSTRUCTIONS
(only for machines with drain pump)
The drain pump works automatically only
during the washing cycle to discharge the
exceeding water coming from the rinsing cycle.
At the end of the working day, in order to
completely discharge the tank, it is necessary
to perform the following operations:
1. Open the door of the Ware-washer;
2. Remove the overflow pipe from the tank;
3 . Afterwards push button "F" for 3 seconds.
Control lamp "E" and the cycle lamp (the last
chosen) are flashing alternatively.
The discharge will stop automatically after 5
minutes. Control lamps will stop flashing.
The drain can be stopped at any time by pressing
again button ''F'' .
Reinstall the overflow and shut the hood.
RINSING ADDITIVES
To grant a perfect rinsing, a quick drying and to
avoid calcareous sediments on glasses and
cups you must add a surfactant on water
(Brightner).
Your cleansing agent supplier's will be able to
suggest the most
machine is equipped with a rinse-aid dispenser.
Mean concentration used is 0,15 g/lt.
24
suitable product. Your