Storing The Leaf Blower; Troubleshooting; Disposing Of The Device; Spare Parts List - Sabo SAU17052 Mode D'emploi

WARNING
Never allow brake fluid, petrol, petrol-based products, invasive oils etc. to come into contact with the plastic elements. These chemical products contain substances that can damage,
weaken or destroy the plastic.
12

STORING THE LEAF BLOWER

Clean your leaf blower thoroughly before putting it away. Store the leaf blower in a dry, well-ventilated location and out of the reach of children. Do not store the leaf blower close to caustic
materials such as chemical garden products or salt for de-icing.
· Store and charge the battery in a location at normal ambient temperature. At temperatures below or above normal ambient temperature, the life of the battery is reduced.
·
After the charger's LED turns green, remove the battery from the charger and disconnect the charger from the power supply.
·
Never store the battery discharged. After using the device, wait until the battery has cooled and immediately recharge it.
·
The battery's capacity declines over time. The higher the temperature, the faster the battery loses its capacity. If you do not use your device for longer periods, you should charge the
battery every month or every two months. This extends the life of the battery.
13

TROUBLESHOOTING

See figure 1
PROBLEM
The motor does not start when you press the
release switch (1) on the device.
The device does not start
The device starts, but air does not flow
through the tube.
The speed controller (3) is not working.
14

DISPOSING OF THE DEVICE

Do not dispose of electric devices with household waste. Dispose of these devices at recycling centres. Contact the relevant authorities or your retailer for information about this.
The separate collection of used products and packaging allows materials to be recycled. The reuse of materials helps to prevent pollution and reduces the need for raw
materials.
Dispose of batteries at the end of their use and consider the environment. The battery contains material that is dangerous to you and the environment. Therefore, it must be
disposed of separately in a facility that accepts lithium-ion batteries.
15

SPARE PARTS LIST

·
See spare parts catalogue
POSSIBLE CAUSES
There is no electrical contact between the
machine and the battery.
The battery is empty.
The release switch (1) is defective.
The release switch (1) is defective.
The motor is defective.
The electronic circuit is defective.
The blower tube or the air inlet is clogged.
The screw is loose.
SOLUTION
·
Remove the battery.
·
Check the contact.
·
Re-insert the battery.
Charge the battery.
Have defective parts replaced by an authorised retailer.
Have defective parts replaced by an authorised retailer.
Check the inlet opening and the blower tube for blockages to the airflow. In this case
remove the blockage.
Use a screwdriver to tighten the screw.
26