How To Install The Product - Axis D2110-VE Guide D'installation

How to install the product

1. Use the drill template and drill holes in the wall.
2. Fasten the mounting bracket to the wall.
3. Route the network cable through the mounting bracket. Leave approximately
30 cm (12 in) of cable for connecting the radar.
CAUTION
Risk of water leaks.
• Do not use network cables with capped network connectors because they can cause
tearing of the cable gasket.
• Use cables with a diameter of 5–9.5 mm (0.2–0.4 in).
4. To connect an auxiliary device, for example an I/O or a PTZ camera, repeat the step
above for each cable.
5. Attach the radar to the mounting bracket with the hooks.
1
Hook, bracket side
2
Hook, radar side
6. Loosen the screws on the cover and open the cover.
7. Snap the strut into position to lock the cover in its open position.
8. Tighten the screws with 1 N m (0.7 lb ft) torque.
AXIS D2110-VE Security Radar
13
EN