Battery Removal - Remington NanoSeries Groom Essentials NE3455 Mode D'emploi

ENGLISH
, TO REMOVE HAIR FROM EAR
•
Insert the cutting unit gently into the outer ear canal opening.
•
Gently rotate appliance in a circular motion.
•
Avoid inserting the cutting unit more than 6mm into your ear canal.
, NOTE: Do not apply excessive pressure as this damages the trimmer head
and may cause skin injury.
, CARE FOR YOUR GROOMER
•
Care for your product to ensure a long lasting performance. We recommend
that you clean your groomer after each use.
, WASHOUT PORT INSTRUCTIONS
•
For best results, keep trimmer running while running it under the tap. Allow
water to run through the washout port and over the blades. Recommended
to rinse after each use.
E TROUBLESHOOTING
•
The trimmer is not running but has battery power left:
•
If it is still not running put the head into a glass of hot water with it switched
off and let it soak for 15-20 minutes, then try again to switch the unit on.
, AFTER EACH USE
•
Rinse the accumulated hair from the cutters as noted above and shake off
excess water.
C CLEANING CAUTIONS
•
Do not use harsh or corrosive cleaners on the units or their blades.
•
Do not apply pressure or hard objects to cutters.
•
Do not submerge in water as damage will occur.

BATTERY REMOVAL

•
Rotate the battery compartment cap approximately ¼ turn anti-clockwise
then pull off.
•
Place the cap back on the unit opposite to how it came off and rotate
clockwise until the cap snaps into place.
•
The battery must be removed from the appliance before it is scrapped.
•
The battery is to be disposed of safely.
5