essentiel b ERA 553 Notice D'utilisation page 33

When the selected fan is in speed 2, it switches to speed 1 after 40 minutes, and then
continues to operate at this speed continuously.
"CoolAir"
Press the "Cool Air"
1.
cooling system. The indicator lamp
Press the button again to deactivate the function. The indicator lamp
2.
Note: if the water tank is empty and the "Cool Air" function is activated, the unit beeps and
the indicator lamp for the "Cool Air" button
automatically disabled. (Refer to the "Installation - Filling the water tank" section).
"Oscillation"
This function allows you to change the horizontal direction of the air emitted by the unit:
Press the button on the control panel or on the remote control to switch on oscillation.
1.
The indicator lamp
Press the button again to deactivate the function. The indicator lamp
2.
off. The air will then flow in the direction in which you stopped the oscillation.
Settingthetimer
Repeatedly press the
1.
operating time of the unit (from 1 to 7 hours) before it will automatically switch to standby
mode. The lit indicator lamp(s) indicate the selected time.
Example 1: you want to select a duration of 3 hours, press the
•
and "2h" lamps are lit.
Example 2: to select a duration of 7 hours, press the
•
"4h" (1 + 2 + 4 =7) lamps are lit.
The indicator lamps for the timer indicate the number of hours remaining before the unit
•
stops and will turn off as the time elapses.
The unit will automatically stop when the selected time has elapsed.
•
To cancel the programming, press the
2.
again until all the indicator lamps go out.
button on the control panel or remote control to activate the
will light up.
will turn on and air oscillation will start.
button on the control panel or remote control to select the
flashes on the control panel. The function is
button until the "1h", "2h" and
button on the control panel or remote control
will switch off.
will switch
button until the "1h"
V.4.0
use
33