Bluetooth - ELAC EA Serie Mode D'emploi

BLUETOOTH

The EA101EQ-G has two connections for Bluetooth. One is for Bluetooth Audio Streaming,
(playing music from a phone or tablet via Bluetooth through the EA101EQ-G). The other is for
use with the EA101EQ-G App.
Minimum Bluetooth Requirements:
Bluetooth Version: v4.0 or better to run the EA101EQ-G App
Bluetooth Profiles: A2DP for Bluetooth Audio Streaming and AVRCP for IR control of a paired
phone or tablet
BLUETOOTH PAIRING (BLUETOOTH AUDIO STREAMING)
1. Confirm that Bluetooth is ON on the phone or tablet to be used by going to Settings and
then Bluetooth in the device menu.
2. On the EA101EQ-G IR Remote, press the
input. Next, press and hold the
the front panel display.
3. Under Available Devices, look for: ELAC USB Amplifier. This is the connection for Bluetooth
Audio Streaming. Tap it. It should pair to the EA101EQ-G.
4. To test, press the
Play some music on the paired phone or tablet. It should play through the amp. If not,
repeat Steps 1-3 to confirm the ELAC USB Amplifier Bluetooth connection.
Appropriately featured smartphones, tablets and other devices can be paired to
the EA101EQ-G Amp via Bluetooth for Bluetooth Audio Streaming. The EA101EQ-G IR
Remote can be used to control transport functions, (play/pause, previous/next track) on
appropriately featured phones and tablets for additional control flexibility. See Section: IR
Remote Features for additional information.
BLUETOOTH PAIRING (EA101EQ-G App)
The EA101EQ-G App is a setup app that can run on either Android or iOS devices. The
Android version can be downloaded from Play Store. The iOS version can be downloaded
from App Store.
1. With the app downloaded and installed, confirm that Bluetooth is ON on the phone or
tablet to be used by going to Settings and then Bluetooth in the device menu.
2. Launch the EA101EQ-G App. A black ELAC Screen will appear with an instruction to
select a device from the list. Tap EA101EQ-G Control and the app will sync to the amp.
Typically, once the app has been synchronized to the amp from a phone or tablet, unless
the app gets uninstalled, the app will automatically sync to the EA101EQ-G amp if the
amp is in range and the app has not been turned off. If the app gets tuned off and gets
relaunched on a previously paired phone or tablet, the app will automatically sync when
launched.
3. To confirm that the app is synchronized to the amp, tap the Analog 1, Analog 2, Coax,
etc labels at the top of the Master Volume screen. If the source shown on the amp front
panel display changes with the source selected from the app, the app is synchronized.
IMPORTANT NOTE: Bluetooth can be simultaneously connected to two devices, but only
one can play at a given time. If one stops playing, the other can then play. If one device
is connected another can be paired without disconnecting the connected device. If two
devices are connected a new device cannot be paired without disconnecting one of the
connected devices.
button to start the pairing process. 'BT Pair' will appear in
button on the IR Remote to select the Bluetooth input on the amp.
button to switch the amp to the Bluetooth
13
Bluetooth