Foreword; Packaging; Commissioning - Yak 108/C Manuel D'utilisation Et D'entretien

FOREWORD

Dear Customer, before using your new jack, please read these instructions carefully and familiarise yourself with the safety
symbols.
- This manual is an integral part of the machine, and as such must be kept safe and to hand so the operator is able to
consult it whenever needed.
- The contents of this manual comply with the Machinery Directive 2006/42/EC, and the jack is type approved in conformity
with European Standard EN 1494, as amended.
- The manufacturer reserves the right to make modifications without prior notice, without prejudice to the safety and main
technical characteristics, and shall bear no liability in such an event.
- Failure to observe these instructions may result in personal injury or even death.
- The manufacturer shall not be liable for any damage or injuries caused by incorrect or improper use of the product. The
identification plate is placed on the jack.DWG. 1

PACKAGING

- The body and other parts of the jack are packed in a three-ply corrugated cardboard box with pallet; the operating and
maintenance manual plus the warranty certificate in a folder are also inside the box.
- The instruction "Keep upright" is clearly visible on the cardboard box containing the jack.
- Depending on the number of jacks shipped, pallets of different sizes are used.
- Either transpallets or forklift-trucks are used for handling.

COMMISSIONING

ASSEMBLY
1. Take the handle and the jack out of the box
2. Unscrew the two nuts
3. Remove screws A A
4. Insert the handle with its coupling in the corresponding groove in the chassis, inserting the previously removed
parts in the hole in the handle. Screw in screw
5. Connect the two air hoses coming out of the handle to the corresponding quick couplings in the chassis, matching
the colours as indicated by the label on the chassis itself. DWG. 10
6. The handle must be fitted so that the distributor
VIEW YAK108/C VIEW YAK108/C
12
D - EXPLODED VIEW YAK108/C D - EXPLODED VIEW YAK108/C
from the chassis and remove parts
from inside the chassis
C,B C,B .
A A and then tighten with nut
E E is facing towards the lifting arm of the jack (see
D D
EXPLODED EXPLODED
EN