Beta 7041LCD/4S Notice D'utilisation Et Instructions page 10

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
TROUBLESHOOTING
FAQs
Filters do not darken, or
Reaction is slow
Filter is not clear
The mask slips
DISPOSAL
The crossed-out wheelie bin symbol on the equipment or packaging means that the product should
be collected separately from other types of urban waste at the end of its useful life.
Any user who is going to dispose of this tool can:
• in case of a product for professional use only, contact the manufacturer which will arrange for the product to be properly
disposed of.
Proper disposal of this product allows the raw materials contained in it to be reused and prevents
damage to the environment and human health.
Illegal disposal of this product is a violation of the provision concerning the disposal of hazardous
WARRANTY
This equipment, which is manufactured and tested in accordance with current EU regulations, is covered by a 12-month
warranty for professional use or a 24-month warranty for nonprofessional use.
pieces or replacing them at our discretion. Should assistance be required once or several times during the warranty period, the
expiry date of this warranty will remain unchanged.
This warranty will not cover defects due to wear, misuse or breakdowns caused by blows and/or
falls. This warranty will no longer be valid if any changes are made, or if the equipment is forced or sent to the customer service
in pieces. This warranty explicitly excludes any damage to people and/or things, whether direct or consequential.
We hereby declare, assuming responsibility, that the described product complies with the relevant provisions of the following
Directives:
• 2016/425/EU PERSONAL PROTECTIVE EQUIPMENT – PPE
The Technical Brochure is available at:
BETA UTENSILI S.P.A.
Via A. Volta 18,
20845 Sovico (MB)
ITALY
10
CAUSES
Protector is damaged
Arc sensor is not clear
Welding current is too low
Battery is low
Ambient temperature is too low
Sensitivity setting is too low
Protector is stained
Filter lenses have stains
Ambient light is poor
Dark shade has not been set correctly
Headband has not been adjusted
DECLARATION OF CONFORMITY EU
SOLUTIONS
Clean or replace it
Clean sensor surface
Adjust sensitivity to maximum
Replace battery
Do not use below -5 °C
Raise sensitivity properly
Clean or replace protector
Adjust light in workplace
Set dark shade correctly
EN I