Oceanic OCEALED32H20B7 Guide D'utilisation page 72

Menu Operation
Note about updating the FastScan:
The device will check the channel list of the operator FastScan for up to date channel list availability when
switched into Standby mode. To do this, simply switch off the TV at the selected Satellite input. The device will
not stop to power the satellite antenna during the update, the status LED may flash several times. Only after
completion of the update (about 3 minutes) will its consumption fall below the prescribed value of 0.5 W.
Advanced/Special tuning
You can perform advanced and special tuning in the Dish Setup of the satellite.
You can scan one or more satellites, one or more transponders by selection from their list using the button OK. After
selection press blue button and select from the following window three selections:
1. Scanning mode between Default (is searched according to the list on TV), Blind scan (the slowest, searches
many modes and parameters of broadcasting regardless if any broadcasting exists there), Network (first is
scanned for the network table NIT and then are scanned the transponders found there).
Channel type select – Free/FTA, for which reception is not necessary any card of conditional access (CA) and
2.
Scrambled (sometimes called "coded"), where you need an access card. The scrambled channels are displayed
in the list by a symbol of a key.
Service type – select DTV and Radio.
3.
Example of advanced tuning process Skylink:
Set correctly according to your antenna system the satellites' reception Astra 23,5° east (Astra 1E, 1G, 3A).
⚫
(Or check the presence and setting of individual transponders according to the list of the operator.)
⚫
Select (check by pressing OK) in the list of this satellite the transponder 12070 MHz, horizontal polarization,
symbol rate 27500 kSym/s.
⚫
After you press Scan select Network tuning. The television will first find the NIT table on TP12070 and then
tunes in the programs, which are not listed there.
(If you receive also the satellite Astra 19,2° east, tune programs from several transponders of this satellite, if you
paid for these programs and want to receive them.)
⚫
You can delete from the extensive list of programs those, which you do not require, e.g. because they belong to
another operator, whose access card you do not own.
17