GreenWorks Pro GW80VSNW200 Guide D'utilisation page 22

MAINTENANCE
REPLACING THE SCRAPER (See Figure 9)
The scraper is located at the bottom of the impeller housing.
• Ensure that the battery is not installed in the tool.
• Remove the screw (1) from each side plate that holds the scraper and 3 screws (2) from under
the machine that secure the scraper to the machine.
• Remove and discard the old scraper.
• Install the new scraper, and fasten it securely with 5 screws that you previously removed.
(1)
(1)
Fig. 9
(2)
21