Restore Factory Settings; Maintenance And Cleaning - HomeMatic IP HmIP-PSM-CH Mode D'emploi

9

Restore factory settings

The factory settings of the device can be re-
stored. If you do this, you will lose all your set-
tings.
To restore the factory settings of the pluggable switch
and meter, please proceed as follows:
• Unplug the device from the socket (see figure 2).
• Plug in the device into the socket again while
pressing and holding down the system button (A)
for 4s at the same time, until the LED will quickly
start flashing orange (see figure 3).
• Release the system button again.
• Press and hold down the system button again for
4s, until the status LED lights up green.
• Release the system button to finish the proce-
dure.
The device will perform a restart.
10

Maintenance and cleaning

The device does not require you to carry out any
maintenance. Enlist the help of an expert to carry
out any maintenance or repairs.
Before cleaning the device, unplug it from the socket
outlet. Use a dry linen cloth to clean the device. If the
Restore factory settings
37