Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Restoring default settings
The siren settings can be reset and cleared from memory by means of the following procedure:
Step 1:
Deactivate the tamper function on the control unit. If the siren is installed on MP500/xx, access "Maintenance"
mode (see the instruction manual of the control unit for details). The siren will generate an acoustic signal to
indicate that the Tamper switch is off.
Step 2:
Remove the siren from the list of device of the control unit (see the instruction manual of the control unit).
Step 3:
Remove the screw from the bottom of the upper cover and remove the upper cover.
Step 4:
Remove the LED cover by loosening the two screws which fix it.
Step 5:
Move the power switch to the OFF terminal and insert the batteries in the battery housing.
Step 6:
Hold the learn/test button pressed for 3 seconds and move the power switch to BT4. The LED groups will blink in
sequence and the siren will beep.
Step 7:
Release the learning/test button when the beep is heard. The old parameters of the siren will be deleted and it will
return to normal mode.
Step 8:
Reposition the LED cover and fix it with two screws.
Step 9:
Reposition the battery housing cover and fix it with four screws. Be careful not to tighten the screws excessively.
Step 10:
Reposition the upper cover by coupling it to the top of the base. Press the bottom of the upper cover onto the base
and tighten the screw of the bottom.
Step 11:
The siren can be learnt again at this point with default settings.
<NOTE>
If the siren is installed on MP500/xx, it must be deleted from the device light (see the instruction manual of the control
unit for details).
Accessories
The following accessories are provided with the siren:
4 x large anchor bolts
4 x cross head screws 4 mm x 30 mm
4 x alkaline D batteries (pre-inserted) 1.5 V
Technical specifications
Power supply: 4 alkaline batteries, 1.5V type D
Battery life: 5 years (typical value, may vary according to use)
Output sound level: 110dB @ 1 metre
Two-way radio frequency: 868 MHz
Working temperature range -10°C to +45°C
Level of protection: IP56
Dimensions: 83.5 mm x 205 mm x 316.8 mm
Weight: 1.87 kg
Hereby, URMET S.p.A. declares that the radio equipment type: OUTDOOR SIREN WITH FLASHER HP600 is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address:
www.elkron.com
DS80HP8A-001E
SIMPLIFIED EU DECLARATION OF CONFORMITY
11
Publicité
Table des Matières
