Setting Remote Control Code Type; Title Input - Pioneer AXM-P8000 Mode D'emploi

Other Functions
Setting the AUX title
The title displayed for the AUX source can be
changed.
1 After you have selected AUX as the
source, press o and hold until TITLE ap-
pears in the display.
2 Input the title.
To input the titles, refer to Title input on this
page.
Setting remote control
code type
When the remote control operation switch is
set to DVD, changing the remote control code
type enables you to operate the Pioneer DVD
player by the supplied remote control. There
are two remote codes, code type DVD A and
code type DVD B. When using this unit with a
multi-DVD player (e.g. XDV-P90), select code
DVD A. When using this unit with a DVD navi-
gation unit, select code DVD B.
1 Set the remote control selection switch
on the left side of the remote control to
the appropriate position with a pen tip or
other pointed instrument .
! If you select DVH mode, there is no need to
take the following procedure.
! If you select DVD A/DVD B mode, take the
following procedure and change the code
type to the appropriate type.
2 Press 7 and 0 on the remote control si-
multaneously to change the code type.
Initially, the code type is set to DVD A. Each
time you press 7 and 0 simultaneously on the
remote control the code type switches be-
tween DVD A and DVD B.

Title input

You can input titles for discs, digital sources,
analog sources and AUX sources. Refer to the
following procedure and input your desired ti-
tles.
Important
You can use this function only when the remote
control is set to DEQ mode.
1 Press o and hold until TITLE appears
in the display.
2 Press button 1 to select the desired
character type.
Press button 1 repeatedly to switch between
the following character types:
Alphabet (upper case), numbers and symbols
Alphabet (lower case)European letters,
such as those with accents (e.g. á, à, ä, ç)
Numbers and symbols
# You can select to input numbers and symbols
by pressing button 2.
3 Press q or r to select a letter of the
alphabet.
Each press of r will display a letter of the al-
phabet in A B C ... X Y Z, numbers and sym-
bols in 1 2 3 ... | } ¯ order. Each press of q will
display a letter in the reverse order, such as Z
Y X ... C B A order.
4 Press n to move the cursor to the
next character position.
When the desired letter is displayed, press
n to move the cursor to the next position
and then select the next letter. Press m to
move backwards in the display.
Section
09
39
En