Hilti SL 2-A12 Mode D'emploi Original page 21

8 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable
to remedy the problem by yourself, please contact Hilti Service.
8.1 Troubleshooting
Trouble or fault
The battery does
not engage with an
audible double click.
1 LED flashes.
The device does not
work.
9 Disposal
Most of the materials from which Hilti tools and appliances are manu-
factured can be recycled. The materials must be correctly separated before
they can be recycled. In many countries, your old tools, machines or appli-
ances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti
representative for further information.
Battery disposal
Improper disposal of batteries can result in health hazards from leaking
gases or fluids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical
tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶ Dispose of the battery at your Hilti Store, or consult your local govern-
mental garbage disposal or public health and safety resources for disposal
instructions.
▶ Do not dispose of power tools, electronic equipment or batteries as
household waste!
10 RoHS (Restriction of Hazardous Substances)
Click on the links to go to the table of hazardous substances:
qr.hilti.com/r7107441 (SL 2-A12) and qr.hilti.com/r7107460 (SL 2-A22).
*2171355*
Possible cause
The retaining lugs on the
battery are dirty.
The battery is
discharged.
The battery is too hot or
too cold.
2171355
Action to be taken
▶ Clean the retaining
lugs and push the
battery in until it
engages.
▶ Change the battery
and charge the empty
battery.
▶ Allow the battery to
cool down or warm
up slowly to room
temperature.
English 17