Cleaning And Maintenance - Transistor Lynx Mode D'emploi

Troubleshooting
Type of fault
Baby Alarm does not detect sound.
Baby Alarm gives a false alarm.

Cleaning and maintenance

Vacuum outside of Baby Alarm with a soft brush several times per year. Use a lightly moistened cloth to
dry off the exterior. Never use cleaning products or solvents.
Repairs
If the product malfunctions it must be sent to an authorised technician for repair. Do not attempt to
open the case of the device since this would invalidate the warranty. If your product requires service,
please contact your hearing care professional for assistance.
Waste disposal
This product contains electrical or electronic equipment and should be disposed of carefully
in the interest of your safety and the environment. Please contact your local hearing care
professional concerning disposal of the product.
General Precautions
• Low-energy radiation (eg from burglary alarms, room surveillance systems, radio equipment,
mobile telephones) will not damage the device. They could, however, momentarily affect the
sound quality or create noise in the device.
• Warning: External devices connected to the product must be safe according the requirements
of EN 60601-1-1, EN 60335-1 or EN 60065, as appropriate.
Technical data
Frequency:
Modulation:
Battery:
Power consumption:
Aerial:
Range:
Channels:
Function code:
Transmitter power:
Dimensions:
Weight:
Any issues relating to the EU Medical Device Directive
93/42/EEC should be directed to AB Transistor Sweden.
433.92 MHz.
AM.
1 x 9 V type 6LR61 or IEC 6F22.
Standby: approx. 0.2 mA. Transmitting: approx. 16 mA.
Integrated (170 mm), partially concealed in cover.
Up to 30 m indoors.
16.
4 bit (3 bit selectable via microswitches).
<10 mW radiation.
170 x 70 x 45 mm.
approx. 200 g.
Action
1. Check that the battery is OK. 2. Check that
the Baby Alarm is switched on. 3. Check the
sensitivity setting. 4. Switch off pause, if applica-
ble (see page 5).
1. Check sensitivity setting (reduce if necessary).
2. If the receiver is a MiniVib, check that the
alarm symbol on the Baby Alarm is set to Alarm
Call/Pager (see page 6).
ENGLISH
7