Battery Warning - Transistor Lynx Mode D'emploi

ENGLISH
Installing the Baby Alarm
1. Open the blue cover and fit the
battery supplied.
2. Fit the Baby Alarm in the vicinity
of the child's cot, out of reach of
the child.
Switching the Baby Alarm on and off
Switching on: Press On/Off button briefly. The red LED flashes.
Switching off: Hold down On/Off button for four seconds until the red LED goes
off. NOTE: to save the battery, switch off Baby Alarm when not in use.
Adjusting sound sensitivity
To make the alarm more sensitive to the baby's cries, increase sound sensitivity by
turning the knob
than the baby's cries, reduce sensitivity by turning the knob anti-clockwise.
When the child cries
When the child's cries exceed the set sound level, a wireless signal is sent to the recei-
ver installed in the Lynx system. At the same time, the red lamp on the Baby Alarm
lights up for a few seconds.
The alert is given by vibration and symbols, loud noise or flashing light, depending
on the type of receiver.
Read the user manual for the receiver installed!

Battery warning

The Baby Alarm is powered by a battery. Normal service life for an alkaline battery
is about 3 months, and for a lithium battery about 6 months. When battery power
begins to fail, the Baby Alarm will send out an alert. It sends a flat-battery warning
along with the alarm to the receiver in the alerting system.
Read the user manual for the receiver installed!
4
on the front face clockwise. If the alarm reacts to noises other