Hedge Trimmer Safety Warnings - EarthWise CVP41810 Manuel Du Propriétaire

Taille-haie à manche/taille-haie/scie à manche/tronçonneuse combo 4-en-1 convertible électrique
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DANGER – Keep hands away from blade. Contact with
blade will result in serious personal injury.
Use both hands when operating the hedge trimmer.
Using one hand could cause loss of control and
result in serious personal injury.
Keep all parts of the body away from the cutter blade.
Do not remove cut material or hold material to be cut
when blades are moving. Make sure the switch is off
when clearing jammed material. Blades coast after turn
off. A moment of inattention while operating the hedge
trimmer may result in serious personal injury.
Carry the hedge trimmer by the handle with the cutter
blade stopped. Proper handling of the hedge trimmer will
reduce possible personal injury from the cutter blades.
EXTENSION CORD. Make sure your extension cord is in
good condition. When using an extension cord, be sure it is
heavy enough to carry the current your product will draw. An
undersized extension cord will cause a drop in line voltage
resulting in loss of power and overheating. The following
table shows the correct size to use depending on cord length
and nameplate ampere rating. If in doubt, use the next
heavier gage. The smaller the gage number, the heavier the
cord.
Minimum Gage for Cord Sets
Volts
120V
0-25
Ampere Rating
More Not More
Than
Than
0
-
6
18
6
-
10
18
10
-
12
16
12
-
16
14
WARNING: Use out door extension cords marked SW-A,
SOW-A, STW-A, SJW-A, or SJTW-A. These cords are rated
for outdoor use and reduce the risk of electric shock.
DOUBLE INSULATION—Double Insulation is a concept in
safety in electric power tools, which eliminates the need for
the usual three-wire grounded power cord. All exposed metal
parts are isolated from the internal metal motor components
with protecting insulation. Double insulated tools do not need
to be grounded.
NOTE: The double insulated system is intended to protect
the user from shock resulting from a break in the tool's
internal insulation. Observe all normal safety precautions to
avoid electrical shock.
It is possible to tie the extension cord and power cord in a
knot to prevent them from becoming disconnect-
ed during use. Make the knot as shown, then
connect the plug end of the power cord into the
receptacle end of the extension cord. This meth-
od can also be used to tie two extension cords
together.

HEDGE TRIMMER SAFETY WARNINGS

Total Length of cord in Feet
26-50
51-100
101-150
American wire Gage
16
16
16
14
16
14
12
Not Recommended
Hold the power tool by insulated gripping surfaces
only, because the cutter blade may contact hidden
wiring or its own cord. Cutter blades contacting a "live"
wire may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
Keep cable away from cutting area. During operation
the cable may be hidden in shrubs and can be
accidentally cut by the blade.
WARNING – Only use with handle and guard properly
assembled to hedge trimmer. The use of the hedge trimmer
without the proper guard or handle provided may result in
serious personal injury.
POLARIZED PLUGS—To reduce the risk of electric shock,
this equipment has a polarized plug (one blade is wider than
the other). This equipment must be used with a suitable
polarized 2 wire or 3 wire extension cord. Polarized
connections will fit together only one way. Make sure that the
receptacle end of the extension cord has large and small
blade slot widths. If the plug does not fit fully into the
extension cord, reverse the plug. If it still does not fit obtain a
suitable extension cord. If the extension cord does not fit fully
into the outlet, contact a qualified electrician to install the
proper outlet. Do not change the tool plug or extension cord in
any way.
CHECK DAMAGED PARTS – Before further use of the tools,
a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform
its intended function. Check for alignment of moving parts,
binding of moving parts, breakage of parts, mounting and any
other condition that may affect its operation. A guard or other
14
part that is damaged should be properly repaired or replaced.
12
Call our customer service help line at 1-800-633-1501 for
12
assistance.
WARNING: California Proposition 65: This product
contains chemicals known to the State of California to cause
cancer, birth defect or other reproductive harm.
WARNING: Some dust and debris created by the use of this
tool could contain chemicals known to the State of California
to cause cancer and birth defects or other reproductive harm.
Some examples of these chemicals are:
Your risk from exposure to these chemicals varies,
depending on how often you do this type of work. To reduce
your exposure, work in a well-ventilated area and with
approved safety equipment, such as dust masks that are
specially designed to filter out microscopic particles.
WARNING: Cancer and Reproductive Harm -
www.P65Warnings.ca.gov.
WARNING: DO NOT USE ON A LADDER OR UNSTABLE
SUPPORT. Stable footing on a solid surface enables better
control of the power tool in unexpected situations.
4
Model CVP41810
Chemicals in fertilizers
Compounds in insecticides, herbicides and
pesticides
Arsenic and chromium from chemically treated
lumber

Publicité

Table des Matières
loading

Table des Matières