One for All URC-7557 Manuel D'installation page 11

Important notes:
- During steps 2 - 7 (page 9), you have approximately 10 seconds to conduct each
step. If there is a gap of more than 10 seconds between two steps, you will have
to start again from step number 2.
- If you learn a function on a key, the original ONE FOR LL feature automatically
becomes shifted. You can press M GIC then the key to access it (this excludes the
Channel and Volume keys).
- The Learning feature is mode specific. Therefore you can place one learned fea-
ture per mode on the same key.
- If a Shifted Learned function is placed on the Channel and Volume keys then
Colour/Brightness will be sacrificed.
- The ONE FOR LL 5 can learn approximately 25 – 40 functions.
- You can replace a learned function by placing another learned function on top.
- Learning should not be done in direct sunlight or under incandescent lights.
- Make sure you are using new batteries before following the instructions above.
- Upon changing the batteries, your learned functions will be retained.
• Shifted Learning
You can also learn a function on a key of the ONE FOR LL without
sacrificing the original ONE FOR LL function.
also be put on any key EXCEPT for the following: Device keys, M GIC key,
Number keys. To install a Shifted Learning function, simply follow steps 1-8 on
the previous page. During step 5, press M GIC once before you press the key
where you are placing the learned function.
To access the shifted function, press M GIC and then the key you have
learned on.
10
The Learning Feature
Shifted Learning function can
WWW ONEFORALL COM