NITRAM ELITE PRO Serie Manuel D'utilisation page 12

Problem
Circuit breaker has tripped
due to an overload.
Outlet does not Batteries are discharged.
provide power to Unit has been damaged by
equipment. a surge or spike.
Non-critical outlets have
turned off automatically
due to an overload.
Batteries are not fully
The UPS does not
charged.
perform expected
runtime. Batteries are degraded.
The on/off switch is
designed to prevent
damage by rapidly turning it
off and on.
The UPS will not turn
The unit is not connected to
on.
an AC outlet.
The battery is worn out.
Mechanical problem.
The serial cable or USB
cable is not connected.
The cable is connected to
the wrong port.
®
PowerPanel
Personal
The unit is not providing
Edition is inactive.
battery power.
The serial cable is not the
cable that was provided
with the unit.
11
TROUBLE SHOOTING
Possible Cause
Turn the UPS off and unplug at least one piece of
equipment. Wait 10 seconds, reset the circuit breaker by
depressing the button, and then turn the UPS on.
Recharge the unit for at least 4 hours.
Contact Nitram/CyberPower about replacement batteries
at: support-techinque@nitram.fr
Push the toggle button to make the uncritical outlets turn
on.
Recharge the battery by leaving the UPS plugged in.
Contact Nitram/CyberPower about replacement batteries
at: support-techinque@nitram.fr
Turn the UPS off. Wait 10 seconds and then turn the
UPS on.
The unit must be connected to a 220/230/240v outlet.
Contact Nitram/CyberPower about replacement batteries
at: support-techinque@nitram.fr
Contact Nitram/CyberPower about replacement batteries
at: support-techinque@nitram.fr
Connect the cable to the UPS unit. You must use the
cable that came with the unit.
Try another port on your computer.
Shutdown your computer and turn the UPS off. Wait 10
seconds and turn the UPS back on. This should reset the
unit.
You must use the cable included with the unit for the
Software.
Solution