Safety Instructions/Warnings - Fellowes Corsivo Sit-Stand Workstation Mode D'emploi

SAFETY INSTRUCTIONS/WARNINGS

Read and follow all instructions and warnings before use.
• WARNING: PINCH POINT! KEEP HANDS CLEAR OF SUPPORT BARS DURING
OPERATION. SERIOUS INJURY MAY OCCUR.
• DO NOT EXCEED MAXIMUM STATED WEIGHT CAPACITY. SERIOUS INJURY OR
PROPERTY DAMAGE MAY OCCUR.
• Keep cables clear of support bars during operation, follow the cable routing
instruction in this manual. Failure to follow these instructions may result in
equipment damage or personal injury.
• DO NOT lean on the keyboard platform.
• Always use both hands when operating the workstation.
• Make sure the desk or mounting surface is level and can support the combined
weight of the workstation and accessories.
• Remove all equipment and accessories from the workstation before moving.
• Only compatible with Fellowes Monitor Arm Kit for Lotus.
• Manufacturer certifies that product meets or exceeds applicable
ANSI/BIFMA standards.
CONTENTS
Included
A Workstation
B Keyboard Platform
C Threaded Insert/M5x10mm
Pan Head Phillips Screw
A (x1)
D Adhesive Cable Clips
E Foam Pads
F Rubber Feet
Other Tools Required
Phillips Screwdriver
C1/C2 (x4)
2
Corsivo_411433_3L_031419.indd 2-3
ENGLISH
Corsivo™ Sit-Stand Workstation
≤ 15 Kg
≤ 33 lbs
≤ 2 Kg
≤ 4.4 lbs
B (x1)
D (x4) E (x3) F (x4)
SET UP
STEP 1
Remove four M5x10mm pan head Phillips screws (C2) from threaded inserts (C1) using a Phillips screwdriver.
C
STEP 2
Prepare the keyboard platform (B) by applying three foam pads (E) to the bottom surface as shown in the first image. Turn the keyboard platform
(B) upright and insert four threaded inserts (C1) into the top surface.
E
B
STEP 3
Apply four rubber feet (F) to the bottom of workstation (A) and remove plastic strap.
A
F
C1 C2
C1
B
CAUTION: Do Not engage the handle when
removing the plastic strap. Only engage the handle
when the product is in the upright position.
3
3/18/19 12:48 PM