NINCOAIR 180G ARMED FORCES MISSILE Manuel De L'utilisateur page 5

TRANSMITTER
LEFT FIRE
POWER INDICATOR
UP-DOWN
TRIM
INSTALLATION AND BATTERY CHARGE
Transmitter:
Switch in position OFF. Open the battery cover. Fit the batteries (respect polarity). Close battery cover.
Helicopter. There are two ways to charge the battery:
1) Connect the USB cable to the USB port of a computer (preferably) or a
wall charger (not included). Connect the charging plug into the helicopter
(CHA).
2) Switch in position OFF. Open the charger cable cover. Connect the
cable between the transmitter and the helicopter (CHA). Switch ON the
transmitter.
LOADING MISSILES: Slide the missile into the launch tube until a click is heard and feel the missile latched
LAUNCHING MISSILES: Press the left button of the transmitter and the missile of the left side of the helicopter will be launched. Idem for the right
side.
HELICOPTER FLIGHT
Before flight:
1.- With the helicopter battery disconnected,
the transmitter .
2.- Connect the helicopter battery.
3 .- Place the helicopter on the ground (very important for the operation of the gyro), with the tail pointing toward you.
4. Synchronizing transmitter and helicopter: Full push the left stick for a second, then pull back.
Trim adjustments:
1. Push again the left stick SLOWLY to start the flight (approx. between 0,5m and 1m).
2. If the tail turns left or right, please trim it using the trim button on the transmitter. Turn it to the left or the right until the helicopter stops turning.
select the band in the transmitter A, B o C and the helicopter will automatically identify it.
Switch ON the helicopter.
NINCOAIR is brand of NINCO DESARROLLOS S.L.
08940 Cornellà - Barcelona - Spain
CIF B-60307725 - www.nincoair.com
RIGHT FIRE
TRI-BAND CHANNEL
TURN LEFT-RIGHT /
FORWARD-BACKWARDS
POWER/CHARGE
SWITCH
SPEED SELECTOR
5
Crta. de L'Hospitalet 32
HANDBOOK
ENGLISH
CHARGING CABLE
(BACK)
Switch ON