Poulan PD4016 Manuel D'instructions

WARNING! Read and follow all Safety Rules and Operating
Instructions before using this product. Failure to do so can result in
serious injury.
Quick-Start Guide
NOTE: Your product may differ slightly from the item shown.
115887249 Rev. B 2017-03-08
Mix 2.6 oz. of full synthetic 2-
Cycle Oil with 1 gallon of
gasoline for a 50:1 mixture.
Shake well. Pour into fuel tank.
CAUTION: Do not use alternate
fuels such as ethanol blends
above 10% by volume (E-15, E-
85) or any methanol blended fuel.
Add bar and chain oil to oil tank
until full.
Make sure chain brake is locked
by pushing forward on
handguard.
Slowly press primer (air purge)
bulb 10 times.
Pul Pull blue choke lever out fully.
Place right foot in rear handle as
shown. Using right hand, pull
starter rope sharply until machine
starts, or a maximum of 5 times.
Push blue choke lever to half
choke position.
NOTE: In temperatures above
90°F (32°C), push blue choke
lever completely in.
n Starting a Warm Engine
+ + +
NOTE: If the product does not restart, the problem could
be overheated fuel.
To fix this problem, try the following procedure:
1. Set the product in a cool area away from direct sunlight.
2. Allow the product to cool for at least 20 minutes.
3. Press primer (air purge) bulb repeatedly for 10- 15 seconds.
4. Follow the cold starting procedure.
Repeat this procedure if the problem still exists.
NOTE: Always use fresh seasonal fuel and shorten
operatio n time during unseasonably warm weather.
IMPORTANT:
Never let your saw chain come in contact with soil/dirt
·
during operation. This will completely dull your chain
and will require installation of a new chain.
Check your chain tension prior to each time you start
·
the chainsaw. Check tension on a new chain after the
first 15 minutes of operation. See the manual for chain
tensioning instructions.
Instruction Manual
PD4016 / PD4218
Pull starter rope until engine
starts.
Allow engine to warm for 30
seconds. Squeeze throttle trigger
to set normal idle.
Before accelerating to full
throttle, make sure chain brake is
unlocked by pulling back on
handguard.
Press red switch to STOP
position when finished using saw.
SASA242MC