Publicité
Les langues disponibles
Les langues disponibles
Cutting of the original undertray
Fitting kit
- 1 metal plate holder
- 2 BHc 5x10 screws
- 2 M5 nuts
- 2 Ø5 plastic washers
- 1 large steel washer Ø20 thickness : 3mm
Assembly
- Remove both saddles, the passenger handle and the rear fairing.
- Remove the original undertray and cut it as shown on the photos. Cut both fixations of the
undertray on the lock (see photo).
- Replace the undertray on the motorbike with its original fixations and the rear fairing.
- Place the lock on the provided part by inserting the large washer between the undertray and the
support fork. Fit the plate holder with the provided screws and nuts and then the indicators.
- Position the undertray by placing it around the taillight and assemble it with both fixations of the
rear fairing.
- Refit the rear fairing, replace the passenger handle and connect the indicators.
- Fix the number plate on its support.
It is advised to check the slope of the number plate before assembly, and if
necessary, fold the plate metal support so as to preserve a slope in the
standards (do not fold the metal support while inserted in the ABS piece).
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the
technical data of our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Any deterioration of the parts due to the presence of any excessive load in the undertray will not be guaranteed.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
FITTING INSTRUCTIONS
CBF 125 2009 → ∞
Original tyre : TVS Tyres 100/90 ZR17
Original undertray after cutting
« CAUTION »
« UNDERTRAY »
Cutting of the undertray's fixations
Publicité
