Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 2 chrome rods Ø10
- 4 drilled cylinders L : 30mm
- 2 screws CHC 8×50
- 4 chrome metallic washers Ø6
Assembly
- On the scooter: cut the caps under the nose fairing to access the fixations of the scooter.
- On the windshield: insert one screw 6x20 in the chrome washer and a rubber washer first, then through the
windshield, then into a second rubber washer. Screw the drilled cylinder loosely to adjust if necessary. Repeat
on the four attachment points.
- Place the rods through the cylinder holes.
- Install the unit (windshield with fixations) on the fitting points located below the scooter's nose fairing
thanks to the screws 8x50 as indicated on the plan above. Tighten all screws once the unit is placed and
centered.
The fixations are provided for a "universal" mounting: positioning
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
KYMCO PEOPLE/SHADOW GTI 125/300 2010 → ∞
Countersunk screws 6x20
Wide rubber washers Ø6
- 4 countersunk head screws 6×20
- 8 wide rubber washers Ø6
- 2 metallic washers Ø8
adjustments are necessary.
« CAUTION »
FITTING INSTRUCTIONS
« SPORTIVO WINDSHIELD »
Screws CHC 8x50
Drilled cylinders
L : 30mm
Rods Ø10
Metallic
washers Ø8
Publicité
