Explanation Of Buttons; Opperation; Programs - Tunturi Cardio Fit Bike 30 Manuel De L'utilisateur

English

Explanation of buttons

Up
- Increase resistance level
- Setting selection.
Down
- Decrease resistance level
- Setting selection.
Mode
- Confirm setting or selection.
Reset
- In setting mode, press RESET key once to reset
the current function figures.
- Press RESET key and hold for 2 seconds to reset
all function figures
Start/ Stop
- Start or Stop workout
Body Fat
- Test body fat% and BMI in stop mode.
Recovery
- Test heart rate recovery status.

Opperation

Power on
- Plug in power supply to power on computer.
- Press any key to power on the console when
being in sleep mode..
- Start pedalling to power on the console when
being in sleep mode.
LCD will display all segments (fig. - F-01)
Power off
Without any signal being transmitted into the
monitor for 4 minutes the monitor will enter
SLEEP mode automatically. ( Active training data
will be lost )
Workout selection
Use UP/ DOWN to select:
- Manual
- Program
- User Program
- H.R.C.
- Watt
18

Programs

Quick start
- Press START/ STOP key to start your workout
without any pre-set setting.
- Use UP/ DOWN to adjust resistant level during
workout.
End your workout
- Press START/ STOP in workout mode to stop/
pause your workout.
To resume your workout press START/ STOP
button in pause mode.
- Press and hold RESET key for over 2 seconds
to reset console. ( Active training data will be
lost )
Manual mode
- Use UP/ DOWN key to select workout program,
choose MANUAL mode and press mode key
to enter next setting entry for manual mode
program.
- Use UP/ DOWN key to pre-set training time,
and press Mode to confirm the setting.
- After confirm you can set also:
distance, Calories, and Pulse.
‼ NOTE
• When setting more than one goal, the
training will end at first achieved goal.
• Leave a goal blank and it will not be seen as
a pre-set limit.
- Press START/ STOP key to start workout
- Use UP/ DOWN key to adjust resistance level.
- Load level is shown in LOAD window.
Program mode
- Use UP/ DOWN key to select workout program,
and select MODE to confirm.
- Use UP/ DOWN key to select Program P1 ~ P12
and press MODE to confirm. ( fig. F-02)
- Use UP/ DOWN key to set TIME.
- Press START/ STOP key to start workout.
Press START/STOP key to pause workout.
- Use RESET to go back to main menu.
User Program
- Use UP/ DOWN key to select workout program,
and select MODE to confirm.
- Use UP/ DOWN key to create user profile.
- Set tension level for first of 20 colums, and
confirm with MODE to set second level, repeat
this for all colums.