Install The Hardware - Axis T92E Serie Guide D'installation

AXIS T92E05/T92E20 Installation Guide

Install the hardware

Install the wall bracket
1. Use the supplied drill template to prepare a wall or pole for installation of the wall bracket.
2. Route the network cable through the wall bracket according to the wall bracket illustration in
Hardware overview, on page 6. Leave approximately 30 cm (11.8") of cable for connecting the
camera.
3. Install the wall bracket on a wall or pole and make sure that the screws and plugs are
appropriate for the material (e.g. wood, metal, sheet rock, stone).
Route the network cable through the cable hole
1. Loosen the cable cover screws; detach the cable cover from the bottom cover.
Cable gland
2. Remove the cap, the plug and the gasket from the cable gland that is to be used.
3. Route the network cable through the cap.
4. Slide the network cable through the slit on the gasket to attach the gasket to the network
cable.
5. Route the network cable through the cable gland.
6. Press the gasket into the cable gland and screw the cap on firmly.
Gasket
Plug (discard)
Cap
Page 7