Getting Started - Tommee Tippee Light and Sound Sleep Aids Mode D'emploi

Getting started

Important! Please read these instructions carefully before use and keep for future reference.
Charging your light and sound sleep aid
To charge, insert the mini USB connector of the power lead into the charging port on the battery pack
and the USB connector into any standard USB charger (120-240V).
DO NOT connect a USB lead to a standard plug socket.
The indicator light on the battery pack will glow red whilst charging. When the indicator light glows
blue, it is fully charged. The indicator light goes off when not connected to a power source.
Make sure its fully charged before first use. It will take approx. 5 hours to fully charge the battery.
When it is fully charged, the battery should last approx. 25 hours on the highest energy use and 75
hours on lowest energy level.
When charging, pull the battery box out of the back opening. It will remain attached but not touching
the plush material.
Only adults should charge your light and sound sleep aid.
Only plugs that are approved to BS1363 should be used (UK only).
Note: Your light and sound aid will not work while the battery is charging.
6
function switch
indicator light
charging port
How to use
Your light and sound sleep aid has 4 limbs that you use to control lullabies, sounds, volume and light.
To choose a lullaby
Press the left arm. Press once
for Brahms Lullaby, twice for
Hush Little Baby and three
times for Twinkle Twinkle
Little Star.
The lullaby music will play
for 20 minutes before it
automatically switches off,
unless you have selected the
CrySensor on the battery pack.
If you want to activate the
CrySensor without playing
music for 20 minutes, press
the left arm for 5 seconds.
The sound will stop and
the CrySensor will be
activated if CrySensor
is switched on.
To turn the light on
Press the left foot to turn
on the light. Choose the
brightness level by pressing
repeatedly. The pattern is
low – mid – high – off.
The light will automatically
turn off after 30 minutes.
To change the volume or turn off
When your light and sound
sleep aid is playing a sound or
lullaby press their right foot to
select the volume. The pattern is
low – off – high – mid – low – off.
When silent press the right foot
to select the last sound played
and change the volume. The
pattern is high – mid –low – off.
Fabric loop
Attach the light and sound
sleep aid to a cot, car seat or
pushchair.
To choose a sound
Press the right arm. Press
once for heartbeat, twice for
rainfall and three times for
white noise static.
The sound will play for
20 minutes before it
automatically switches off,
unless you have selected the
CrySensor on the battery
pack.
If you want to activate the
CrySensor without playing a
sound for 20 minutes, press
the right arm for 5 seconds.
The sound will stop and the
CrySensor will be activated
if CrySensor is switched on.
7