Husqvarna 27005979000 Mode D'emploi page 6

Final steps
Make sure that the silencer is not touching any other parts of the motorcycle.
Remove all grease residue with a soft cloth sprayed with multi-purpose lubricant.
Cleaning prevents stains from baking onto the surface. Do not use aggressive chemical cleaners.
Test the function of the brakes and suspension. Make sure that all screws are tightened. If the exhaust system is touching the
trim or other parts, readjust the unit or contact your authorized dealer.
When the exhaust system is fi rst put into operation, it is normal for white smoke to be emitted by the silencer.
Finally, check for leaks in the whole exhaust system.
Do not stand behind the exhaust when it is being used for the fi rst time.
Maintaining the exhaust system
Perform a visual inspection every 2000 km. As soon as the silencer cover becomes discolored, the damping wool must be
checked and changed if necessary.
The damping wool must be replaced after 15,000 km at the latest. Wear and tear to the damping material of the silencer de-
pends on driving style.
Periodically check whether all screws are suffi ciently tight.
Spare parts
Rock wool kit
Repair kit
Silencer cap
6
- Position side cover (with exhaust heat shield).
- Position side cover in holding lugs

- Mount screw and tighten to 3.5 Nm.

- Mount screws and tighten to 8 Nm (Loctite 243).
Final steps
- Mount the seat (see the Owner's Manual).
- Take the motorcycle off the lift stand (see the Owner's Manual).
When you fi rst use the main silencer, keep the engine speed
low for about 5 minutes to warm the main silencer evenly. This
is the only way to ensure that the rock wool will reach its full
effectiveness and keep noise down to the required level!
27005979010
27005979020
27005979050
 
and engage in area .