Chauvet Professional Ovation E-190WW Manuel De Référence page 3

EN
What Is
Included
AC Power
Power Linking
AC Plug
Replacing the
Fuse
DMX Linking
DMX
Connection
Master Control
Master/Slave
Connection
·
OVATION™ E-190WW
·
Neutrik® powerCON®
power cord
·
Safety Cable
This product has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
You can link up to 4 OVATION™ E-190WW products at 120 VAC or 7 at
230 VAC. Power linking cords can be purchased separately.
Connection
AC Live
AC Neutral
AC Ground
1.
Disconnect this product from power.
2.
Using a Phillips #2 head screwdriver, unscrew the fuse holder cap
from the housing.
3.
Remove blown fuse and replace with a good fuse of the same type and
rating.
4.
Screw the fuse holder cap back in place and reconnect power.
The OVATION™ E-190WW will work with a DMX controller using a
regular DMX serial connection. A DMX Primer is available from
www.chauvetprofessional.com.
The OVATION™ E-190WW uses a regular DMX data connection for its
DMX personalities: UNO, DOS, and STD.P. See the User Manual to
connect and configure for DMX operation.
The OVATION™ E-190WW allows control of other OVATION™
E-190WW products using a regular DMX data connection. See the User
Manual to configure for Master Control operation.
The OVATION™ E-190WW uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
OVATION™ E-190WW QRG
·
·
Wire (U.S.) Wire (Europe)
Black
White
Green/Yellow Green/Yellow
3
Warranty Card
Quick Reference Guide
Screw Color
Brown Yellow/Brass
Blue Silver
Green