Cleaning And Maintenance - Whirlpool AGB 626/WP Notice D'emploi

2g) Replacing thè nozzles
Put thè appliance upside down and loosen the screws of the panel, take out thè finned cover of thecombustion chamber, loosen the screws
of the burners support.
Slide thè burner and. with a proper spanner, unscrew the nozzle and replace it with the correct one.
After fitting the nozzle, before screwing back the panel, turn the appliance and verify the correct combustion and reset thè primary air.
Warning :
After setting the appliance for another type of gas indicate the modifìcation in the technical data label.
3) SPECIAL MANTAINANCE
Before doing anything else disconnect the appliance and dose the gas valve.
The following maintenance programme shouid be carried out at least once a year suggesting thè user to subscribe a maintenance contract :
and check all thè setting devices and thè safety thermocouples
- check that thè burner is working properly and clean it
- check thè combustion
- check the leaks of pressure ( valve-cocks, gas pipes)
- check thè structure and all the components, replace them if worn out or broken.
When thè burner should be cleaned, follow indications brought in paragraph 2f) " replacing of the nozzle" to get to the burner and take it
out carefully.
Clean carefully thè burner openings with compressed air, if the openings are too dirty is better to change the buirner.
4) DIRECTIONS FOR USE
4a) Turning thè burners on and off
Open the gas safety valve upstream the appliance.
Press thè knob and, keeping it pressed, turn it counter-clockwise to position
To obtain minimum power turn it counter-clockwise to position.
To unlit the burner turn the knob clockwise to position O.
When the appliance is not operating keep the safety gas cock closed.

5) CLEANING AND MAINTENANCE

Before doing anything else and dose the gas valve.
Never wash the appliance with a jet of water as this causes dangerous infiltration in the components.
A daily cleaning will keep the appliance in perfect working order and make it lasi longer.
The stainless steel parts must be treated with non abrasive detergents avoiding the use of steel wool that may cause rust forming.
The control panel and the knobs must be cleaned with a soft humid cloth.
The plates must be carefully cleaned with a steel brush or a steel wool.
Is advisable to clean the lukewarm plates and to keep them shining is advisable to use vinegar.
After cleaning and rising the plates spread a thin coat of oil prevent rust from forming.
The appliance shoulde be subjected to a maintenance programme carried out by qualified personnel at least once a year.
For this reason we suggest to stipulate a maintenance.
WHIRLPOOL EUROPE srl
V.le Guido Borghi, 27
I – 21025 Comerio – VA
13