Lanaform Mixy Mode D'emploi page 6

To clean the tank unit:
EN
1) Clean the water tank with a soft cloth and use vinegar if there is scale or chalky deposits on its interior.
2) If there is scale covering the cut-out switch, pour a few drops of vinegar on it and clean with a brush.
3) Rinse the tank with clear water.
Storage:
1) Carefully clean and dry the ultrasound humidifier, following the maintenance instructions.
2) Let it dry completely before placing in storage. Do not store it with water remaining in the base.
3) Store the appliance in a cool and dry place away from children.
TROUBLESHOOTING
If the appliance malfunctions in everyday use, please refer to the table below:
Breakdown
No blowing, no vapour
Blowing but no vapour
Strange-smelling vapour
Low intensity
The vapour is not rising
Noise
6
Possible causes
No power
The vapour intensity control is at
minimum
Water level in the groove is too high.
Water tank leak
No water in the tank
The temperature of the device is too
low.
The water has been in the tank too
long.
The vapour intensity control is at
minimum
Sediment on the transducer.
The water is too cold.
The water is unclean.
The vapour intensity control is at
minimum
The tank and the base are not
connected properly
The fan is not working correctly
Resonance due to the water level in
the tank being too low
Resonance due to an unstable surface Place the unit on a stable surface
Remedies
Plug in the appliance
Adjust the vapour intensity
Remove the water from the trough
Tighten the lid correctly
Fill the tank
Place the device in the room at room
temperature for half an hour prior
to use.
Clean the tank and fill with fresh
water.
Adjust the control button
Clean the transducer.
Use water at room temperature.
Clean the tank and fill with fresh
water.
Adjust the vapour intensity
Check that they are connected
properly
Return appliance to supplier or after-
sales department.
Add water to the tank.