- Place the clamps on the handlebar by using, if necessary, one or
several half-rings in order to adjust the handlebar diameter.
- Assemble the metallic bars Ø10 on the clamps as shown on the
photo.
- Then fit the windshields with the large plastic screws.
- Adjust the position of the windshield and lock firmly the clamps.
NB: for strength of your plastic collars, a moisture period is required after injection: soak collars in hot
water and let cool 12 hours to room temperature.
Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged. Ermax accessories are foreseen for
original equipments. They will not be guaranteed if they are used in others conditions. Due to vehicles made tolerances, beyond our control, some Ermax products