Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 3 rubber inserts
- 3 BHc 5×20 screws
- 3 Ø5 plastic washers
- 3 Ø6 plastic washers
Assembly
- Place the screen on the meter block of the bike by centring it the best you can.
- Track down the central hole by knowing that the axis of this one is in 10,5 cm of the meter's cover and
drill in the Ø9,5 (photo 1).
- Fix the screen thanks to one insert (the washer taking place between the screen and the insert).The
whole is blocked by the Ø5 screw and washer.
- Track down both holes aside by centring the screen. The axis of every holes is in 3,5 cm of the edge of
the meter's cover (photo 2).
- Drill and fix with the supplied kit's remaining.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
Photo 1
FITTING INSTRUCTIONS
"ATTENTION"
"NOSE SCREEN"
ER 6 N 2006 / 2008
Assembly time estimated: 15 mn
Photo 2
Publicité
