Publicité
Les langues disponibles
Les langues disponibles
Location of the BHc screws, the
rubber washers and the M6 nuts.
Fitting kit
- 2 brackets
- 4 BHc 6×10 screws
- 4 M6 nuts
Assembly
- Remove the original side fixations, then the headlight.
- Position the provided brackets thanks to the 2 CHc 6×10 screws (see pictures). Seen of face, the
brackets must deviate from the headlight.
- Replace the headlight and the original side fixations.
- Place the nose screen and fit it by using the 4 BHc screws, the 4 rubber washers and the 4 nuts
remaining
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicules made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
Location of the fitting brackets
- 4 Ø6 rubber washers
- 2 Chc 6×10 screws
- 2 Ø6 steel washers
«
»
WARNING
FITTING INSTRUCTIONS
« NOSE SCREEN »
GSR 600 2006/2007
Location of the CHc 6×10 screws
Publicité
