Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 4 rubber inserts
- 4 screws BHc 5×15
- 4 plastic washers
- 1 support
Assembly
- Remove cover from above headlight (2 plastic rivets).
- Remove light unit (the central screw is circled in the photo).
- Put the supplied support in place and fix it at the sides with the plastic rivets. Replace the light unit
and cover using the original screws.
- Fit the 4 inserts to the support, fix the 4 screws and washers on the screen and tighten.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
Position of plastic rivets
« CAUTION »
FITTING INSTRUCTIONS
« NOSE SCREEN »
CB 600 HORNET 2007/2010
Publicité
