Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 3 plastic inserts
- 3 screw 5×25
- 2 bumpons
Assembly
- Position the nose screen on the clock control panel, ensuring it is correctly centred.
- Mark the central hole (the centre of this one is at 10,5 cm from the top of the cover), and drill a 9,5
mm hole.
- Fit the nose screen with one insert and one spacer. The spacer is placed between the nose screen
and the insert. Lock the whole with one screw and one washer Ø5.
- Mark the two side holes by centring well the nose screen. Drill and fix with the rest of the fitting
kit.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
- 3 plastic washers Ø5
- 3 plastic spacers Ø6 x 10mm
Distance
10,5 cm
CAUTION
FITTING INSTRUCTIONS
« NOSE SCREEN »
Z 750 N 2007 → ∞
Estimated assembly time : 15 mn
Publicité
